Garbage Disposal
Bay Area's #1 Choice

The labor for a standard garbage disposal replacement typically ranges from $150 to $500. This assumes the existing electrical outlet and plumbing trap are in good condition. If we need to run new wiring or modify the sink flange, we provide a direct, updated quote on-site.

The average lifespan of a high-quality unit is 10 to 12 years. If your disposal is over a decade old and starts to leak from the bottom or requires frequent resets, the internal seals and motor are likely failing. In these cases, replacement is more cost-effective than repair.

A humming sound means the motor is receiving power, but the flywheel is jammed. This is usually caused by a foreign object (like a fruit pit or a small utensil) wedged between the impellers and the grind ring. We use a manual override to clear the jam and reset the internal breaker.

Leaks from the very bottom of the unit usually indicate that the internal motor seal has perished, or the outer shell has corroded through. These are non-repairable failures. If the leak is coming from the top or the side connections, we can usually resolve it by replacing the mounting gasket or tightening the discharge pipe.

Horsepower (HP) determines the motor’s ability to grind tough food waste. A 1/2 HP unit is suitable for light use in 1-2 person households. A 1 HP motor is recommended for larger families because it grinds waste finer and faster, which significantly reduces the risk of drain clogs.

This often happens when food waste collects in the "P-trap" or the discharge tube. We clear the plumbing lines and check the disposal’s internal grind chamber to ensure waste is being pulverized correctly before it enters the drain.

No. You should always use cold water. Cold water keeps fats and grease in a solid state so the disposal can chop them up. Hot water melts grease, allowing it to coat your pipes further down the line, which leads to stubborn, deep-system clogs.

If the reset button trips frequently, the motor is either overheating or struggling against an obstruction. This is often a sign that the motor is reaching the end of its life or that the unit is undersized for waste you are processing.

Yes. Most disposals have a dedicated inlet for the dishwasher drain hose. During installation, we remove the "knockout plug" and secure the hose to ensure your dishwasher drains directly into the disposal, preventing food particles from clogging your main kitchen line.

Yes. A leaking disposal can quickly cause water damage to your kitchen cabinets and subflooring. We offer 24/7 emergency response to replace failing units or secure leaking connections, preventing long-term structural damage to your home.