Faucet Installation
Bay Area's #1 Choice

The labor cost for a standard faucet installation typically ranges from $150 to $500. This price assumes the existing shut-off valves are functional and the sink mounting holes match the new faucet’s configuration. If we need to replace corroded supply lines or modify the countertop, we provide a clear, updated estimate on-site.

A standard replacement usually takes 1 to 2 hours. This includes removing the old unit, cleaning the mounting surface, installing the new faucet, and testing the supply lines and drain assembly for leaks. If the old hardware is severely rusted or seized, the process may take slightly longer.

This is often caused by construction debris or mineral sediment getting trapped in the ceramic cartridge during the initial flush. We prevent this by flushing the lines before final assembly. If a drip occurs later, it usually indicates a defective cartridge or a loose internal O-ring that needs adjustment.

If your current "angle stop" valves are over 10 years old or show signs of mineral crusting (calcification), we recommend replacing them. Old valves often fail to close completely or leak from the stem when turned, which can lead to a flood if you need to shut off the water in an emergency.

Yes. We install homeowner-provided fixtures, provided they are compatible with your sink’s hole configuration (single-hole, 4-inch center-set, or 8-inch widespread). We ensure the mounting is secure and the connections are leak-free, though the manufacturer’s warranty typically covers the fixture itself.

Low flow at a single fixture is usually caused by a clogged aerator or a "water-saving" restrictor that is too aggressive. We check the aerator for sediment and verify that the supply hoses aren't kinked behind the cabinet. If the pressure is still low, we inspect the cartridge for internal blockages.

Most 2026 models use ceramic disc cartridges, which are nearly maintenance-free and don't wear out like old-fashioned rubber washers. Compression valves use a screw-down mechanism that eventually leaks as the washer degrades. We recommend ceramic disc faucets for better long-term reliability.

Yes. Most single-hole faucets come with a matching "deck plate" (escutcheon) that covers the extra holes in your sink or countertop. This allows for a clean, modern look without needing to replace the entire sink.

In older faucets, this is caused by mineral buildup or dried-out lubricant inside the cartridge. For new installations, it may indicate that the retaining nut is over-tightened. We calibrate the handle tension during installation to ensure smooth operation.

Most bathroom faucets include a matching pop-up drain assembly. Kitchen faucets typically do not, as they are often connected to a garbage disposal or a separate basket strainer. We verify your existing drain's condition and can install a matching assembly to ensure a complete, leak-free system.